Assembly - Shop-Vac Shop-Pac SP Series User Manual

6. Position left shoulder pad along back plate so textured section
is facing down and smooth side is facing up. Make sure there
are no twists in shoulder strap.
7. Straighten shoulder strap above left shoulder pad so there are
no twists in strap. Slide strap into top hole on left side of back
plate.
8. Fold strap over top of back plate and slide end of strap into
top slot in strap adjuster so you can still see top section of
adjuster.
9. Slide end of strap into bottom slot in strap adjuster so you can
still see bottom section of adjuster.
10. Repeat steps 6 to 9 using right shoulder pad, right shoulder
strap and top hole on right side of back plate.
11. To install the back plate and harness assembly to the tank
refer to the Installing Back Plate and Harness Assembly
section in this manual.
PAGE 6
ASSEMBLY (CONT'D.)
SHOULDER
PAD
SHOULDER
STRAP
STRAP
ADJUSTER
SHOULDER
STRAP
STRAP
ADJUSTER
STRAP
ADJUSTER
BACK
PLATE
BACK
PLATE
BACK
PLATE
SHOULDER
STRAP
BACK
PLATE
SHOULDER
STRAP