Assembly - Shop-Vac 92P Series User Manual

TOP HANDLE
If the top handle is not installed on your unit, align holes in handle and holes in motor
cover and secure with screws provided.
CASTER SYSTEM
Follow the instructions for the caster system that came with your vacuum.
PLASTIC TANK WITH REAR CASTER BASKET
You will find four casters, two caster feet, one basket and four screws with your wet/dry
vacuum.
1. With cord disconnected from receptacle and tank cover removed, turn tank upside
down so that the bottom is facing up.
2. Take basket and place into slots (on rear of tank opposite of drain). Secure with
screws provided.
3. With tank drain facing you, take caster foot marked with the letter A and
place in slot on left side of tank also marked with the letter A. Secure with
screw provided.
4. Take caster foot marked with the letter B and place in slot on right side of
tank also marked with the letter B. Secure with screw provided.
5. If flat washers are included in hardware package place flat washer over stem of caster before installing
casters into feet or basket. NOTE: Flat washers are not required with all units.
6. Install casters into caster feet and basket by inserting the
caster stems into the holes provided. Apply pressure and
twisting motion until caster snaps into place.
METAL TANK WITH PLASTIC DOLLY AND REAR WHEELS
You will find two casters, two large rear wheels, one axle, tool rack, six screws, four metal washers, and
two hair pin clips. If your vacuum is 16 U.S. gallons (60.5 litres) or larger you will also find two screws, two
metal flat washers and two square nuts with your wet/dry vacuum.
Assemble as follows:
1. Make sure the cord is disconnected from the receptacle then remove the tank cover.
2. With the tank upright and back facing you, insert square nut into one of the two
slots located in back of dolly.
3. Place metal flat washer over stem of screw.

ASSEMBLY

Caster
Foot
Caster
Caster
Foot
Screw
Screw
Caster
Foot
PAGE 5