Unpacking And Set-Up; Assembly - Shop-Vac ESSSQ550 User Manual

UNPACKING
AND SET-UP
1. Pull lid latches in an outward motion and remove tank
cover. Remove any accessories and literature which may
have been shipped in the tank.
2. Attach rear wheels and front casters following the
instructions and illustrations below.
3. Before replacing tank cover, refer to Dry Pick Up or
Wet Pick Up Operation in this manual to ensure you
have the proper filters installed and inlet deflector is
positioned correctly for your cleaning operation.
4. Replace tank cover and apply pressure with thumbs
to each latch until it snaps tightly in place. Make sure
both lid latches are clamped securely.
5. Insert long machine hose end with locking-nut into
inlet of tank and tighten. Do not over-tighten.
FIGURE 1
7. Attach one of the cleaning accessories (depending
on your cleaning requirements) on the extension wands.
Twist slightly to tighten the connection. FIGURE 1.
8. Plug the cord into the wall outlet. Your cleaner is
ready for use.
I = ON, O = OFF
NOTE: MANY MORE USEFUL TOOLS ARE
AVAILABLE AT YOUR LOCAL DEALER OR SHOP-
VAC WEBSITE.
®
REAR WHEEL AND
FRONT CASTER

ASSEMBLY

FIGURE 2
PAGE 4
6. Attach the extension wands
(not standard with all
models) to the accessory
end of the hose. Twist slightly
to tighten the connection.
FIGURE 1.
You will find two casters.
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 5
Assemble as follows:
FIGURE 6
FIGURE 7
FIGURE 8
Two axle housings.
FIGURE 3.
Two wheel plugs.
FIGURE 4.
Two wheels. FIGURE 5.
and two screws with your
wet/dry vacuum.
9. With cord disconnected
from receptacle and tank
cover removed, turn tank
upside down so that the
bottom is facing up with the
inlet towards you.
FIGURE 6.
10. Insert caster into bottom
of tank by placing stem of
caster into holes provided.
Apply pressure and twisting
motion until casters snap into
place. FIGURE 7.
11. Mount wheel onto axle
with smooth face of wheel
outward. FIGURE 8.