Sharp SX-51A7 Operation Manual page 22

Further Hints
Ventilation
When setting up the TV receiver, make sure that the ventilation holes in the bottom and rear
panel allow free access of air. Therefore do not place the receiver on a pillowlike surface, on
sponge rubber or plastic foam mats, or on any similar material which could block the ventilation
holes. The upper ventilation grills of the rear panel must not be covered up at any point. The
placing within the vicinity of radiators or other heating devices should be avoided.
NOTE: Antenna Connections
300 to 75
ohm
1. FOR YOUR
SAFETY INSTALL
ANY EXTERNAL
AERIAL
TO AS 1417.1*
2.
Antenna connections
FLAT RIBBON
75 OHM COAXIAL CABLE: Connect the cable
from the antenna to a standard DIN 45325 plug
(IEC 169-2) and plug direct into the socket at the
rear of the television receiver.
300 OHM FLAT RIBBON FEEDER.
Connect the feeder from the antenna to the
Balun, for VHF/UHF etc.
Coaxial Cable 75R
ACCESSORIES SUPPLIED: Operation manual, remote control handset, batteries, service centre
directory.
SPECIFICATIONS
Receiving system:
Receiving channel:
Antenna:
Semiconductors:
Speaker:
Audio Output:
Power Source:
Power Consumption:
Weight:
Dimensions:
PAL System, (Australian Standard)
VHF: 0-llch UHF: 28-69ch
VHF/UHF: 75 ohm
16 ICs, 51 Transistors, 106 Diodes, 1 LED
9 x 5 cm Oval x 2
4.OW t 4.OW (MPO)
230-24OV, AC 50Hz
105W at 24OV, AC 50 Hz
Approx. 23 kg
516(W) x 4i7(H) x 482(D) mm
The manufacturer reserves the right to vary specifications and design, or use alternative materials
as may be deemed necessary or desirable at any time, and such change or variation being of
a kind as not to reduce the quality, performance or appearance substantially.
21