Table of Contents
Advertisement
l-
MONO
0
P-N
1
MONO
P
3 Audio Mode Selector
( I$'a
)
ihe audio mode selector is used to select the
nain, sub or main t sub audio modes of
)ilingual
broadcasting,
and to select the
;tereo or mono mode while receiving stereo
signals.
f
this button is pressed during the main audio
node, reception
switches over to the sub
audio mode. If it is pressed again, reception
iwitches over to the main t sub audio mode.
f
it is pressed a third time reception returns
3 the main audio mode. When this button is
bressed while receiving stereo signals, the
nono mode will be selected. When this button
5
pressed a second time, the stereo mode will
be selected.
lath audio mode indicator will be displayed
In the screen as shown below.
Audio Mode
On Screen Display
Main audio
MAIN
Sub audio
1
SUB
I
Main
+ sub audio
1
MAIN
+ SUB
I
Stereo
Mono
STEREO
MONO
3Mono
button (MONO)
f a stereo broadcast suffers from annoying
loise and the stereo indicator (on the screen)
s blinking, press the mono button to change
he audio to the mono mode.
?I switch the mode back to stereo, press this
jutton again.
NOTE:
If you press the mono button when receiving
a bilingual
programme,
the audio channel
is
switched
to the main channel.
"MAIN",
"SUB",
or "MAIN
+ SUB"
on the
screen
will go
off. To switch back the audio
channel
into the original
mode, press the
button
again.
(The built-in
stereo decoder
uses the Australian
system.)
13
- Quick Links:
- Controls & Terminals
Hide quick links:
Advertisement
Table of Contents
