Rangemaster Elite SE User Manual page 27

110 dual fuel fsd
Table of Contents

Advertisement

Lift up the ends of the plastic clips (one each side) to
release the catches holding the drawer to the side
runners and at the same time pull the drawer forward
and away from the side runners. For safety's sake
push the drawer runners back out of the way. Put
the drawer some where safe - do not refit it until the
installation is complete.
Lower the Rollers.
Fit the Allen key tool to the centre roller lowering
mechanism (C in the fig. below).
A - left rear roller, B - right rear roller, C - centre roller
LOWER THE FRONT ROLLER by doing 14 complete
(360°) turns clockwise.
Now LOWER THE TWO REAR ROLLERS.
First fit the levelling tool on the hexagonal adjusting
nut as shown below.
Make 10 complete (360°) turns clockwise. (This means
turning and removing the levelling tool 20 times).
Check the appliance is electrically safe and gas sound when you have finished.
INSTALLATION
Make sure you lower BOTH REAR ROLLERS. There are
two adjusting nuts, one for each roller, at both the
front bottom corners of the cooker.
Unfold the rear edge of pack base tray. Carefully push
the cooker backwards into position. Take care not to
damage the power cable. Push the cooker close to
its final position, leaving just enough space to get
behind it.
Levelling
You are recommended to use a spirit level on a shelf
in one of the ovens to check for level.
Place the cooker in its intended position taking care
not to twist it within the gap between the kitchen
units as damage may occur to the cooker or the units.
The rollers can be adjusted to level the cooker. To
adjust the height of the rear of the cooker use the
levelling tool supplied to turn the adjusting nuts at
the front bottom corners of the cooker.
Adjust the height of the front roller to level the
cooker. Turn clockwise to raise the cooker and
anticlockwise to lower.
When you are satisfied with the height and level,
raise the front of the cooker by one turn of the front
roller adjuster. Screw down the front feet to meet the
floor. Screw the front roller adjuster anticlockwise to
raise the front roller so that the front of the cooker is
supported on the feet, not the front roller, to prevent
accidental movement of the cooker.
27

Advertisement

Table of Contents
loading

Table of Contents