Lexus RC 350 AWD 2019 Owner's Manual page 70

70
2-1. Instrument cluster
outside temperature may not be dis-
played, or the display may take longer
than normal to change:
• When stopped, or driving at low speeds
(less than 12 mph [20 km/h])
• When the outside temperature has
changed suddenly (at the entrance/exit of
a garage, tunnel, etc.)
● When "_ _"or "E" is displayed, the system
may be malfunctioning.
Take your vehicle to your Lexus dealer.
Pop-up display
■
● In some situations, such as when a switch
operation is performed, a pop-up display
will be temporarily displayed on the
multi-information display or the odome-
ter/trip meter screen (F SPORT models).
● Some pop-up displays can be set on/off.
(P.76)
Customization
■
The meter display can be customized on
the multi-information display. (P.339)
WARNING
■ The information display at low tem-
peratures
Allow the interior of the vehicle to warm
up before using the liquid crystal infor-
mation display. At extremely low tem-
peratures, the information display
monitor may respond slowly, and display
changes may be delayed.
For example, there is a lag between the
driver's shifting and the new gear num-
ber appearing on the display. This lag
could cause the driver to downshift
again, causing rapid and excessive
engine braking and possibly an accident
resulting in personal death or injury.
NOTICE
To prevent damage to the engine and
■
its components
● Do not let the indicator needle of the
tachometer enter the red zone, which
indicates the maximum engine speed.
RC350AWD_RC350_RC300AWD_RC30
0_OM_(U)_1810
The engine may be overheating if the
●
engine coolant temperature gauge is
in the red zone (H). In this case, imme-
diately stop the vehicle in a safe place,
and check the engine after it has
cooled completely. (P.309)
Odometer and trip meter dis-
play
Display items
■
 Odometer
Displays the total distance the vehicle has
been driven.
 Trip meter A/trip meter B
Displays the distance the vehicle has been
driven since the meter was last reset. Trip
meters A and B can be used to record and
display different distances independently.
 Distance until next engine oil
change
Displays the distance the vehicle can be
driven until an oil change is necessary.
Changing the display
■
Each time the "ODO TRIP" switch is
pressed, the displayed item will be
changed. When the trip meter is dis-
played, pressing and holding the switch
will reset the trip meter.