Lexus RC 350 AWD 2019 Owner's Manual page 224

224
5-5. Using the other interior features
 Indicator light flashes rapidly: The
garage door opener motor or other
device is equipped with a rolling
code. To complete programming,
firmly press and hold the Home-
®
Link button for 2 seconds then
release it.
 If the garage door or other device
does not operate, proceed to "Pro-
gramming a rolling code system".
5
Repeat the steps above to program
another device for any of the
remaining HomeLink
Programming a rolling code sys-
■
tem
2 or more people may be necessary to
complete rolling code programming.
1 Locate the "Learn" or "Smart" but-
ton on the garage door opener
motor in the garage.
This button can usually be found where the
hanging antenna wire is attached to the
unit. The name and color of the button may
vary by manufacturer. Refer to the owner's
manual supplied with the garage door
opener motor for details.
2
Press and release the "Learn" or
"Smart" button.
RC350AWD_RC350_RC300AWD_RC30
0_OM_(U)_1810
Perform
performing 2.
3
Press and hold the desired Home-
Link
®
for 2 seconds and release it. Repeat
buttons.
this sequence (press/hold/release)
up to 3 times to complete pro-
gramming.
If the garage door opener motor operates
when the HomeLink
the garage door opener motor recognizes
the HomeLink
Enabling 2-way communication
■
with a garage door (only available
for compatible devices)
When enabled, 2-way communication
allows you to check the status of the
opening and closing of a garage door
through indicators in your vehicle.
2-way communication is only available
if the garage door opener motor used
is a compatible device. (To check
3 within 30 seconds after
®
button (inside the vehicle)
®
button is pressed,
®
signal.