Turn signal lever
Operating instructions
The lever will return to its original posi-
tion immediately after operation.
1
Right turn
2
Lane change to the right (move the
lever partway and release it)
The right hand signals will flash 3 times.
3
Lane change to the left (move the
lever partway and release it)
The left hand signals will flash 3 times.
4
Left turn
If the turn signals do not stop flash-
■
ing after turning left or right, or if
you want to stop them flashing
Operate the lever in the opposite
direction to either position
you move the lever to either position
or 4, the selected turn signals will flash.
RC350AWD_RC350_RC300AWD_RC30
0_OM_(U)_1810
4-2. Driving procedures
Turn signals can be operated when
■
The engine switch is in IGNITION ON
mode.
■
If the indicator flashes faster than usual
Check that a light bulb in the front or rear
turn signal lights has not burned out.
If the turn signals stop flashing before a
■
lane change has been performed
Operate the lever again.
Customization
■
Some functions can be customized.
(P.339)
2
or 3. If
1
133
4