Ignition Park Interlock; Brake/Transmission Shift Interlock System; Eight-Speed Automatic Transmission - Dodge Charger SRT 392 2017 Operating Information Manual

NOTE:
You must press and hold the brake pedal
while shifting out of PARK.

Ignition Park Interlock

This vehicle is equipped with an Ignition Park
Interlock which requires the transmission to be
in PARK before the ignition can be turned to the
OFF mode. This helps the driver avoid inadver-
tently leaving the vehicle without placing the
transmission in PARK. This system also locks
the transmission in PARK whenever the ignition
is in the OFF mode.
Brake/Transmission Shift Interlock
System
This vehicle is equipped with a Brake Transmis-
sion Shift Interlock system (BTSI) that holds the
gear selector in PARK unless the brakes are
applied. To shift the transmission out of PARK,
the engine must be running and the brake pedal
must be pressed.
The brake pedal must also be pressed to shift
from NEUTRAL into DRIVE or REVERSE when
the vehicle is stopped or moving at low speeds.

Eight-Speed Automatic Transmission

The transmission gear range (PRNDM) is dis-
played both on the gear selector and in the
instrument cluster.
To select a gear range, press the lock button on
the gear selector and move the selector rear-
ward or forward. To shift the transmission out of
PARK, the engine must be running and the
brake pedal must be pressed. You must also
press the brake pedal to shift from NEUTRAL
into DRIVE or REVERSE when the vehicle is
stopped or moving at low speeds (refer to
"Brake/Transmission Shift Interlock System" in
this section). Select the DRIVE range for normal
driving.
Automatic Transmission Gear Selector
The electronically-controlled
adapts its shift schedule based on driver inputs,
along with environmental and road conditions.
The transmission electronics
calibrating; therefore, the first few shifts on a
new vehicle may be somewhat abrupt. This is a
normal condition, and precision shifts will de-
velop within a few hundred miles (kilometers).
Only shift from DRIVE to PARK or REVERSE
when the accelerator pedal is released and the
vehicle is stopped. Be sure to keep your foot on
the brake pedal when shifting between these
gears.
The transmission gear selector has PARK, RE-
VERSE, NEUTRAL, DRIVE, and MANUAL
(Autostick) shift positions. Manual shifts can be
made using the Autostick shift control (refer to
"AutoStick" in this section for further informa-
tion). Toggling the gear selector forward (-) or
rearward (+) while in the MANUAL (AutoStick)
position (beside the DRIVE position) will manu-
ally select the transmission gear, and will display
the current gear in the instrument cluster as M1,
M2, M3, etc.
NOTE:
If the gear selector cannot be moved to the
PARK, REVERSE, or NEUTRAL position (when
pushed forward) it is probably in the MANUAL
(AutoStick, +/-) position (beside the DRIVE po-
sition). In MANUAL (AutoStick) mode, the trans-
mission gear is displayed in the instrument
cluster (as M1, M2, M3, etc.). Move the gear
transmission
selector to the right (into the DRIVE [D] position)
for access to PARK, REVERSE, and NEUTRAL.
are self-
Gear Ranges
DO NOT race the engine when shifting from
PARK or NEUTRAL into another gear range.
NOTE:
After selecting any gear range, wait a moment to
allow the selected gear to engage before accel-
erating. This is especially important when the
engine is cold.
189