Jy-Module; Sia Module - Siemens SIPART PS2 6DR5020 Series Manual

Installation

2.5.5 Jy-module

Function
Installation

2.5.6 SIA module

SIPART PS2 Manual
A5E00074631-01
The alarm module is pushed in underneath the motherboard into the
module rack up to the stop and connected by the enclosed 8-wire rib-
bon cable (5) to the motherboard (see figure 2-10, page 27).
With the J -option module, the current actuator position can be output
y
as a two wire signal J = 4 to 20 mA – potentially isolated from the
y
standard controller. The dynamic control of the J
error self--reporting.
The J - module is pushed in to the bottom compartment of the module
y
rack up to the stop and connected by the enclosed 6-wire ribbon cable
(6) to the motherboard (see figure 2-10, page 27).
The SIA module contains:
- a digital output for outputting a group fault message (see alarm
module)
The floating digital output is implemented as a self error reporting
semiconductor output.
- two digital outputs for reporting two mechanically adjustable limit
values (L1, L2) by slot initiators.
These two outputs are electrically independent of the rest of the
electronics.
Design and Functional Principle
-module makes it also
y
31