Rheem 812 Series Owner's Manual And Installation Instructions page 29

Continuous flow gas water heater
Table of Contents

Advertisement

TEMPERATURE ADJUSTMENT – DELUXE CONTROLLERS
A controller must be on with the PRIORITY indicator displayed to be able to adjust the temperature setting.
The temperature adjustment is made by pressing the up () button or down () button.
The minimum temperature setting for each type of controller is 37°C.
The maximum temperature setting for the controllers are:
Each press of the up () button will increase the temperature setting by one increment.
Pressing and holding the up () button will scroll the temperature setting up to a maximum 43°C if there
is hot water flowing or 45°C if there is no hot water flowing.
From the 45°C setting, the up () button must be pressed once for each increase in temperature
increment.
The temperature setting cannot be increased above 43°C whilst hot water is flowing.
Each press of the down () button will decrease the temperature setting by one temperature increment.
Pressing and holding the down () button will scroll down the temperature setting.
The temperature setting can be decreased from any temperature setting whether the hot water is flowing
or not.
Note: A Deluxe controller sounds a double beep at the 42°C temperature setting, if the voice prompt is not
speaking, when either the up () button or down () button has been pressed. The double beep does not
sound at the 42°C temperature setting when the BATH FILL TEMPERATURE up () button or BATH FILL
TEMPERATURE down () button is pressed.
60°C – AU, 55°C – NZ
874 series
876 series
TEMPERATURE CONTROL – DELUXE
Kitchen
Bathroom
50°C
29
50°C
50°C

Advertisement

Table of Contents
loading

Table of Contents