Yamaha Phazer Venture Lite PZ50MTA 2011 Supplementary Service Manual page 63

SPEC
CABLE ROUTING
PZ50GTA, PZ50RTA, PZ50MTA
Clamp the tail/brake light lead
with the clamp. Face the end of
the clamp downward.
Insert the end of the seat lower
plate under the seat rail bracket.
Clamp the tail/brake light lead
with the clamp. Install the clamp
with its buckle positioned to the
inside of the tail/brake light lead
and its end facing downward.
Seat lower plate
Route the tail/brake light lead
outside of the seat lower plate.
After installing the seat lower
plate, put the rubber cover on
the seat rail. Put out the clamp
of the seat rail from the hole of
the rubber cover.
Tail/brake light
Tail/brake light lead positioning
tape
0 ~ 20 mm (0 ~ 0.79 in) from the
end of the positioning tape
Rubber cover
Using the tail/brake light lead
positioning tape as a guide,
clamp the tail/brake light lead
as shown in the illustration. Fold
the end of the clamp so that the
lead does fall off.
Seat rail
Insert the rib of the rubber cover
between the tail/brake light
bracket and seat rail.
Tail/brake light bracket
53