Yamaha Phazer Venture Lite PZ50MTA 2011 Supplementary Service Manual page 51

PZ50GTA, PZ50RTA, PZ50MTA
Connect the branch line of the
oil pressure sensor and oil pres-
sure switch to the oil pressure
sensor and oil pressure switch
in the engine section.
Fuel hose
Clamp the corrugated tube, oil
pressure sensor lead, oil pres-
sure switch lead, and throttle
position sensor lead the frame
front cross member with the
clamp.
Clamp the corrugated tube to
the headlight stay with the
clamp.
Headlight stay
Injector sub-wire harness cou-
pler
Rectifier/regulator
Fasten the fuel hose with the
hose clip. Face the ends of the
hose clip outward, angled 45°
downward.
Collar
Wire harness
Speed sensor coupler
Clamp the speed sensor lead
and fuel tank breather hose to
the frame rear cross member
with the clamp. For routing,
order insignificant.
To the auxiliary DC jack
Hose protector
Drive guard
Clamp the speed sensor lead
and fuel tank breather hose with
a clamp. For routing, order
insignificant.
Clamp the speed sensor lead
and fuel tank breather hose with
the lead holder (be sure to bend
the holder so that the lead and
hose will not come loose). For
routing, order insignificant.
Clamp the speed sensor lead
with the lead holder (be sure to
bend the holder so that the lead
and hose will not come loose).
For routing, order insignificant.
Cylinder identification sensor
Ignition coil
To the handlebar switch
Frame rear cross member
CABLE ROUTING
Ground lead
To the speed sensor
Align the paint mark on the fuel
tank breather hose with the top
of the grommet. During installa-
tion, soapy water may
applied to the grommet hole.
41
SPEC
be