Connecting The Monitor - Philips Dell W2300 Service Manual

Connecting your PC
CAUTION: Before performing any of the setup procedures listed below,
read and follow the safety instructions.
A. Connection through blue VGA & lime green audio cable
1. Connect one end of the blue VGA cable to the VGA plug on W2300,
and connect the other end to the VGA plug on your PC.
2. Connect one end of the lime green audio cable to the audio jack by
the D-sub plug on W2300, and connect the other end to the Audio
jack on your PC.
OR
B. Connection through white DVI cable & lime green audio cable
1. Connect one end of the white DVI cable to the DVI plug on W2300,
and connect the other end to the DVI plug on your PC.
2. Connect one end of the lime green audio cable to the audio jack by
the DVI plug on W2300, and connect the other end to the audio jack
on your PC.
Connecting as a TV
Cable TV
I1. f your Cable TV signal is a single, round cable (75 ohm), then you're
ready to connect to the TV. Connect the TV cable to the
ANTENNA/CABLE plug on the TV.
2. If you have a cable converter box, connect the cable TV signal to the
IN (put) plug on the converter, connect the OUT(put) plug from the
converter to the 75 (ohm) plug on the TV.
3. Verify that the On Screen Display (OSD) is set to Cable. 3.
Note: The connecting cable for the converter is supplied by the Cable
TV company.

Connecting The Monitor

Antenna
1 If your antenna has a round cable (75 ohm) on the end, then you're
2. Push the round end of the adapter (or antenna) onto the 75 (ohm)
3. Verify that the On Screen Display (OSD) is set to Antenna. 3.
ready to connect it to the TV. If your antenna has flat, twin-lead wire
(300 ohm), you first need to attach the antenna wires to the screws
on a 300 -to 75- ohm adapter.
plug on the back of the TV. If the round end of the antenna wire is
threaded, screw it down finger tight.
W2300 5
Go to cover page