Visual Characteristics; Test Conditions - Philips Dell W2300 Service Manual

110
W2300
Go to cover page
S-Video, Component, or Composite as main Input
signal input
Video DPMS
ON(video
power
saving ON) Video Display
Video DPMS
OFF(video
power
saving OFF) Video Display
* Message for DPMS: "In Power Save Mode" \n "Press any key
on keyboard or move mouse"

4.0 Visual characteristics

4.1 Test conditions

Unless otherwise specified, this specification is defined under the following conditions.
(1) Input signal
(2) Luminance setting: controls to be set to 360 nits with
(3) Warm up: more than 30 minutes after power on with signal supplied.
2003-10-31
Robert Lin
GENERAL PRODUCT SPECIFICATION
no signal input
show input source name on Top -
Left coner,ex:AV,S -
VIDEO,HD/CVI,if no video in till
30 minutes,go into video power
saving mode(audio system
working during OSD message
exists),If in power saving
mode ,press any key will show
the input source name again
show input source name on Top -
Left coner,ex:AV,S -
VIDEO,HD/CVI,never turn off the
back light(audio system working)
and never go into powering
saving after 30 minutes with no
Signal in
Note
: As defined in 3.3.1.4, 1280 x 768
non-interlaced mode (60 Hz), signal
sources must have 75 ohm output impedance.
full screen 700mV white signal.
(4) Ambient light: 400 -- 600 lux.
(5) Ambient temperature: 25 +/- 2 °
23" Wide LCD Monitor / TV
TYPE : IL3MT2W/76
Brand : Dell
2003-10-31
8639 000 15069
590 36
50