Canon EOS 20D Service Manual page 34

9-5 Noise reduction:
9-6 Self-timer:
9-7 Self-timer operation:
indicator
9-8 Camera shake warning:
10. Drive
10-1 Drive modes:
10-2 Continuous shooting:
Settable with C.Fn-02 (Noise reduction for long
exposures)
(1) Works with shutter speeds from 1 sec. to
bulb.
(2) After the exposure ends, the same amount
of time as the exposure is required for the
noise reduction.
10-sec. delay
(1) After starting, the self-timer is cancelable
by pressing the drive button again.
(2) With C.Fn-12-1 (Mirror lockup), the self-
timer delay is 2 sec.
1) Red-eye reduction lamp (blinks for the first 8
sec., then lights for the remaining 2 sec.)
2) LCD panel (Frame counter counts down from
10 to 1 sec.)
3) Beeper (beeps at 2 Hz for the first 8 sec., then
at 8 Hz for last 2 sec.)
Provided in Full Auto and Programmed Image
Control modes.
• If the shutter speed (Tv-auto) is 0 to 0.5
stops slower than the reciprocal of the lens
focal length 0 1.25, the shutter speed
display blinks.
[1] Single [2] Continuous [3] Self-timer
(1) Creative Zone modes: [1], [2], and [3] are
settable.
(2) Basic Zone modes: [1] or [2] set
automatically depending on the shooting
mode and [3] is settable.
Continuous shooting with the internal buffer
memory recording.
• The image-processing method switches
automatically to the suit the shooting
conditions.
Note 1: With the EOS 20D's recording quality set to
JPEG, image processing is executed even
during continuous shooting.
Note 2: In the RAW, RAW+JPEG, and WB-BKT modes,
image processing is not executed during
continuous shooting.
29
General Information