Canon EOS 20D Service Manual page 118

<Disassembly Procedure>
1) Terminal cover removal
Remove the 2 screws. Then, remove the
terminal cover while lifting the direction
indicated by the red arrow.
2) Back rubber removal
Peel off the back rubber.
Be careful, the back rubber is reused.
3) Back cover ass'y removal
After removing the back cover ass'y, be sure to protect the TFT monitor
CAUTION
from being scratched or getting dirty.
(1) Remove the 3 black screws, the silver screw and the 2 screws on the bottom.
Then lift the back cover.
(2) Disconnect the flex cable and remove the back cover.
Remove
Fig. 021
<Reassembly Cautions>
Back rubber attachment
Disconnect
Fig. 023
(Description)
11
Repair Information
Remove
Fig. 020
Remove
Fig. 022