Canon EOS 20D Service Manual page 123

Repair Information
2) Bottom cover removal
Remove the 2 screws, and lift and remove the
bottom cover.
3) Grip ass'y removal
Remove the 2 screws from the front and the 2 screws from the side to remove
the grip unit.
4) TFT LCD ass'y removal
(1) Remove the 2 screws.
(2) Disconnect the flex cable connector.
(3) Remove the insulating tape once and remove the lead wire connector. Then,
put the insulating tape back in place.
(4) Unsolder the earth part of the TFT unit.
(5) It will be reused, so be careful not to twist or wrinkle it.
Remove
Fig. 038
Remove
Fig. 040
Fig. 042
Disconnect
Fig. 041
Fig. 043
16
Remove
Fig. 037
Remove
Fig. 039
Unsolder
Disconnect