Table of Contents
Advertisement
Panasonic Electric Works Nordic AB
MEW01295 Rev: 2
Push button
P1
(Depending on
language, etc.
"Alarms queued")
P2
(Depending on
language, etc.
"Acknowledge")
(Depending on
P3
language, etc.
"Silence alarm devices")
(Depending on
P4
language, etc.
"Reset")
P5
(Depending on
language, etc.
13
("Test")
Component
14
Buzzer
Display
Technical Description Alert Annunciation Units 1735 & 1736, ver. 1.4.x
Table of push buttons:
Colour
Operation / function
Black
Used, when LED "L2" is turned on, to scroll
through the queued alarms. (The first alarm will
automatically be shown again after 20 seconds, if
no button is used during that time.)
Yellow
Used to acknowledge an AA alarm. The unit's
buzzer will also be silenced. (Investigation time
starts.) Acknowledged AA alarm is indicated by
LED "L4".
Used to silence the alarm devices.
Red
(Normal fire alarms & AA alarms.)
Used to reset all AA alarm(s). (Fire alarms, i.e.
Green
not AA alarms, have to be reset in the c.i.e.). So
called "encapsulation" is not possible to do.
White
Used for testing the LEDs, the buzzer and the
display (back-light and dots). NOTE! This must
be done only in quiescent condition.
NOTE! Regarding "P1" and "P2", see chapter "SW mode & Address
setting, page 16 and regarding "P3", chapter "SW version", page 27.
Table of others:
Indicating
1 beep/5 s
Cont. + All LEDs
turned off as well.
All or selected Fire alarms / AA alarms presented like in the
c.i.e. that the AA unit is connected to and an alarm text (if
programmed).
indicating a communication fault (i.e. no connection between
the unit and the c.i.e.).
NOTE! Regarding the Buzzer and the Display, see also chapter "SW
mode & Address setting, page 16.
12
If the "Silence alarm devices" button in the c.i.e. has been programmed to
"Disable alarm devices", "P3" will have the same function. "P3" cannot be
used until a fire or AA alarm is activated in the system.
13
Press "P5" (Test) for a test of the LEDs, the buzzer and the display (back-
light and dots). NOTE! This must be done only in quiescent condition.
14
The buzzer may be programmed as "disabled" (via Win512 / Win128 /
Win512 G3), i.e. it will never sound.
AA alarm.
There is a CPU / memory fault in the unit.
(NOTE! A fault message may be shown,
15
12
Advertisement
Table of Contents
