Axis Types, Coordinate Systems, Frames (K2); Signals To Axis/Spindle (Db31 - Siemens SINUMERIK 840Di Function Manual

Detailed Description

2.10 Axis types, coordinate systems, frames (K2)

DB31, ...
DBX72.0 REPOSDELAY
Special cases, The signal is not relevant for path axes.
errors, ......
Corresponds to .... DB21, ... DBX31.0 - DBX31.2 (REPOSPATHMODE)
DB31, ... DBX10.0 (REPOSDELAY)
DB31, ... DBX70.2 (REPOS Delay Ackn)
DB31, ...
DBX76.4 Path axis
Edge evaluation: no
Signal state 1 or The axis is involved in the path (path axis).
edge change
Note
0 → 1
In conjunction with SERUPRO in status "Target block found", the signal refers to the status of the
axis in the target block.
Signal state 0 or The axis is not involved in the path.
edge change
1 → 0
2.10 Axis types, coordinate systems, frames (K2)
2.10
2.10.1

Signals to axis/spindle (DB31, ...)

DB 31, ...
DBX3.0 External Zero Offset
Edge evaluation: no
Signal state 1 or The preselected value of the external work offeset of an axis is used as the new value for
edge change calculating the total work offset between the basic and the workpiece coordinate systems.
0 → 1
Signal state 0 or The preselected value of the external work offset of an axis is not used as the new value for
edge change calculating the total work offset between the basic and workpiece coordinate systems. The previous
1 → 0 value is still valid.
Signal irrelevant $AA_ETRANS[axis] equals zero for all axes.
for ...
Special cases, Signal zero after ramp-up (power ON).
errors, ......
Corresponding to .... $AA_ETRANS[axis]
2-112
Signal(s) updated: cyclic
Signal(s) updated:
NC/PLC Interface Signals (Z1)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0