Brother DCP-L8400CDN Service Manual page 68

Code 1 Code 2
Decoding error continued on 500 lines or more.
A0 13
Decoding error continued for 15 seconds or more.
A0 14
Time-out: 13 seconds or more for one-line
A0 15
transmission.
RTC not found or carrier OFF detected for 6 seconds.
A0 16
A0 17 RTC found but no command detected for 60 seconds
or more.
No video data to be sent.
A0 19
A0 20 Color fax continuous reception impossible
(Low toner level)
RTN, PIN, or ERR received (Sender)
A8 01
A9 01 RTN, PIN, or ERR received (Recipient)
Receive buffer full during receiving into memory.
AA 18
Polarity inversion detection
B0 01
Unable to receive the next-page data.
B0 02
Unable to receive polling even during turn-around
B0 03
transmission due to call reservation.
PC interface error
B0 04
No common modulation mode or failed to poll.
C0 01
Unable to detect JM.
C0 02
Unable to detect CM.
C0 03
Unable to detect CJ.
C0 04
Cannot finish V. 34 negotiation or training.
C0 10
Modem error detected during V. 34 negotiation or
C0 11
training.
Modem error detected during sending of commands.
C0 20
Modem error detected during receiving of commands.
C0 21
C0 22 Control channel connection time-out.
Modem error detected during sending of video signals.
C0 30
Modem error detected during receiving of video
C0 31
signals.
1300 Hz signal detection failure during opposite
E0 01
communication inspection operation.
PB signal detection failure during opposite
E0 02
communication inspection operation.
Command not detected from RS232C in opposite
E0 03
communication.
Cause
2-38
Refer to:
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.5
4.13.2
4.13.2
4.13.2
4.13.2
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
4.13.4
Confidential