Accepting Remote Camera Control; Adjusting The Brightness - Sony IPELA PCS-TL33 Operating Instructions Manual

2
To zoom the image, click the
image.
3
Click the v/V/b/B symbols at the image edges to
adjust the camera angle.
When you right-click the camera image window, the
zoom and angle adjustment buttons disappear and the
launcher screen appears again.
Adjusting the display using the launcher
menu when communication is not in
progress
As described above, right-click the camera image. Zoom
and angle buttons will appear on the display. Perform the
adjustment in the preceding section.
Note
If the lens cover is closed, camera adjustment is not
possible.

Accepting Remote Camera Control

Deselect the "Control by Far End" check box in the
Camera Control menu to reject control of the camera by
the remote party.
Note
Select whether to adjust the remote camera in "Far End
Camera Control" under "Dial" of the Communication
Mode menu.
Zoom
01:25
or button under the

Adjusting the Brightness

The brightness can be adjusted with the Camera Control
menu.
Normally, the brightness is automatically adjusted to
obtain a optimum level. You can also adjust it manually.
It is recommended that the brightness be adjusted
automatically.
Note
Only the brightness of the local camera can be adjusted.
To adjust the brightness
To manually adjust the brightness, deselect the "Auto
Adjust" check box of the "Brightness Adjust" item, and
then click the or button.
Click to brighten the image or
To shoot the picture with backlight
compensation
Use backlight compensation when shooting a subject
against a bright background.
To activate backlight compensation, select the "Backlight
Compensation" check box.
For the local camera, backlight compensation can also be
switched on and off by clicking
making camera adjustments during communication or
from the launcher menu.
Note
If "Auto Adjust" is not selected for "Brightness Adjust",
backlight compensation will not function.
To eliminate flicker
If a fluorescent lamp is connected to the same power
source as the PCS-TL33, flicker may occur in the camera
picture.
To eliminate the flicker, select the "Flicker Removal"
check box.
Using a fixed white balance setting
In the default condition, white balance is adjusted
automatically.
If you want to adjust white balance manually, select the
"Adjust" check box. While draping something white, such
as a piece of paper, in front of the camera, click "Start" and
set the white balance to fit the ambient environment. The
white balance will then be fixed to that setting.
To release the fixed setting
Select the "Auto" check box under "White Balance".
to darken it.
, which appears when
59
Adjusting the Camera