Replacing The Seat And Plug; Replacing The Operating Diaphragm - Samson 2412 Series Mounting And Operating Instructions

7.3 Replacing the seat and
plug
NOTICE
!
Risk of regulator damage due to excessively
high or low tightening torques.
Observe the specified torques on tightening
regulator components. Excessively tightened
torques lead to parts wearing out quicker.
Parts that are too loose may cause leakage.
Observe the specified tightening torques.
NOTICE
!
Make absolutely sure that no torque is ap-
plied to the bellows seal (5.1) during assem-
bly or disassembly. Otherwise, the metal
bellows will be destroyed.
On disassembling the valve, push the cotter
pin of the travel stop cap (see Fig. 3) to "un-
lock". Push it back again to "locked" on re-
assembly. See also the note on the cross-
beam (8).
Note
SAMSON's After-sales Service department
can support you concerning lubricant,
tightening torques and tools approved by
SAMSON.
To replace seat and plug, contact
SAMSON's After-sales Service department.
Further information is available in sec-
tion 10.1.
EB 2512 EN
7.4 Replacing the operating di-
aphragm
NOTICE
!
Risk of regulator damage due to excessively
high or low tightening torques.
Observe the specified torques on tightening
regulator components. Excessively tightened
torques lead to parts wearing out quicker.
Parts that are too loose may cause leakage.
Observe the specified tightening torques.
NOTICE
!
Not for the version for oxygen or complying
with FDA.
Note
There are no spare parts available for the
bellows actuators. The entire actuator must
be replaced when it is defective.
Note
SAMSON's After-sales Service department
can support you concerning lubricant,
tightening torques and tools approved by
SAMSON.
Tip
The associated order number is written on
the actual operating diaphragm.
Maintenance
41