Sony SLV-SE230B Operating Instructions Manual page 74

Sony operating instructions video cassette recorder slv-se830b, slv-se730b, slv-se630b, slv-se230b
Table of Contents

Advertisement

Symptom
The SHOWVIEW menu
or the MINUTERIE
menu does not appear.
The VPS/PDC function
does not operate
properly.
You cannot watch Canal
Plus programmes when
the VCR is in standby
mode.
A Canal Plus programme
is always recorded
scrambled.
A tape cannot be
inserted.
The remote commander
does not function.
The selected input line
connector number does
not appear in the display
window.
The tracking meter does
not appear on the TV
screen.
You cannot control other
TVs.
The display window
becomes dim.
The VCR needs to be
cleaned.
74
Troubleshooting
Remedy
• Check that OPTIONS PROG. in the FONCTIONS
AVANCÉES menu is set correctly (see page 67).
• Check that the clock and the date are set correctly.
• Check that the VPS/PDC time you set is the correct one
(there might be a mistake in the TV programme guide). If
the broadcast you wanted to record did not send the good
VPS/PDC information, the VCR will not start recording.
• If the reception is poor, the VPS/PDC signal might be
altered and the VCR might not start recording.
• Check that DEC is set to OUI for this channel in the LISTE
STATIONS TV menu.
• Make sure the Canal Plus PERITEL cable is plugged
securely.
• Make sure the Canal Plus PERITEL cable is plugged
securely.
• Check that DEC is set to OUI for this channel in the LISTE
STATIONS TV menu.
• Check that a tape is not already in the tape compartment.
• Make sure you are pointing the remote commander at the
remote sensor on the VCR.
• Replace all the batteries in the remote commander with
new ones if they are weak.
• Make sure the [TV] / [MAGN] remote control switch is set
correctly.
• Press CHOIX ENTREE to display the connected line.
• The recording condition of the tape is very poor and
tracking cannot be adjusted.
• Set your TV's code number. The code number may change
when you replace the batteries of the remote commander.
• The display window automatically becomes dim when the
VCR is in standby or timer recording mode.
• Clean the cabinet, panel and controls with a dry, soft cloth,
or a soft cloth slightly moistened with a mild detergent
solution. Do not use any type of solvent, such as alcohol or
benzine.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Slv-se630bSlv-se730bSlv-se830bSnowview slv-se230bSnowview slv-se830bSnowview slv-se730b ... Show all

Table of Contents