Table of Contents
Advertisement
Additional Information
Troubleshooting
If you have any questions or problems not covered below, please consult your nearest
Sony service facility.
Symptom
The ?/1 (on/standby)
switch does not function.
The power is turned on
but the VCR does not
operate.
The VCR is plugged in
but the display window
remains dark.
The clock has stopped
and "– –:– –" appears in
the display window.
The playback picture
does not appear on the
TV screen.
The picture is not clear.
The picture has no
colour.
72
Troubleshooting
Remedy
• Connect the mains lead to the mains securely.
• Moisture condensation has occurred. Turn the power off,
unplug the mains lead and leave the VCR to dry for over
three hours.
• Set VEILLE ECO in the RÉGLAGES UTILISATEUR
menu to NON (see page 65).
• The clock stops if the VCR is disconnected from the mains.
Reset the clock (and timer).
• Make sure the TV is set to the video channel. If you are
using a monitor, set it to video input.
• If the VCR is connected to the TV with the PERITEL
cable, make sure the MAGN or VIDEO indicator is lit in
the display window. Use the t TV/MAGN button on the
remote commander to light up the MAGN or VIDEO
indicator.
• Adjust the tracking with the CHAINE +/– buttons on the
VCR.
• The video heads are dirty (see the last page of
Troubleshooting). Clean the video heads using a Sony
video head cleaning cassette. If a Sony cleaning cassette is
not available in your area, have the heads cleaned at your
nearest Sony service facility (a standard service charge will
be required). Do not use a commercially available liquid
type cleaning cassette other than Sony's, as it may damage
the video heads.
• The video heads may have to be replaced. Consult your
local Sony service facility for more information.
• The SYST. COULEUR option in the RÉGLAGES
UTILISATEUR menu is set to the wrong position. Set the
option to conform to the system that the tape was recorded
in.
Advertisement
Table of Contents
