Sony MSW-M2100 Operation Manual page 85

Menu items in the range 700 to 799, relating to video control (Continued)
Item number Item name
712 VIDEO PROCESS ON
CAP LOCK 2FIELD
713 VIDEO SETUP
REFERENCE LEVEL
(When operating in 525-
line mode)
Sub-Item
0 MASTER LEVEL
3 BETACAM PB
LEVEL
4 OUTPUT LEVEL
Settings
When the function menu item CAPSTN or setup menu item 106 is set to 2F for 2-
field playback, select whether or not to carry out a "picture shift".
OFF : No picture shift
ON: Carry out picture shift.
Note
To eliminate the adverse effect of the residual chrominance subcarrier component
in the Y signal that is the result of the Y/C separation, this unit automatically
applies a shift to the playback image in the H direction, so that even in 2-field
playback a satisfactory image can be obtained.
Set the video setup amounts to be removed from a Betacam playback signal and
to be added to a composite output signal. There are independent settings for a
Betacam signal and a composite output signal (referred to below as an output
signal).
Note
The setup amounts specified in this menu item have no connection with the
function menu item SETUP.
When the Betacam playback signal and output signal settings are "MSTER"
(master), the setup amount specified for this sub-item is removed from the
Betacam playback signal and is added to the output signal.
0.0% ... 7.5% ... 10.0%: Setting in this range, in 0.5% increments.
MSTER : Set the Betacam playback signal to the master setting.
0.0% ... 7.5% ... 10.0%: Set the setup amount to be removed from the Betacam
playback signal in this range, in 0.5% increments.
MSTER : Set the output signal to the master setting.
0.0% ... 7.5% ... 10.0%: Set the setup amount to be added to the output signal in
this range, in 0.5% increments.
(Continued)
8-15
Chapter 8 Setup Menus