Table of Contents
Advertisement
FIGURE 19 – PRINTERS
A printer or laptop can be connected to the Control
Center's Microboard to print the following reports. The
screen from which each report can be generated is listed
in parenthesis.
•
Status - Present system parameters
•
Setpoints - Present programmed values of all set-
points
•
Sales Order - Information on Sales Order Screen
(Printer, Sales Order)
•
History - System parameters at the time of the last
normal stop, last fault while running and last 10
faults, whether running or not (Printer, History)
The printer can be permanently connected to the Control
Center or connected as required to produce a report.
The following figures are examples of the different
print reports.
•
FIGURE 20 - Operating Data
•
FIGURE 21 - Last Normal Stop
•
FIGURE 22 - Sales Order
•
FIGURE 23 - History
•
FIGURE 24 - Purge Trend
•
FIGURE 25 - Setpoints
JOHNSON CONTROLS
SECTION 3
PRINTERS
SEIKO DPU-414
PRINTERS
The following Printer can be used. Printer must be
equipped with an RS-232 Serial interface.
•
Seiko –
Printer: DPU414-30B
Dimensions: 6.3 in. wide x 6.7 in. deep
Paper: 4.4 in. wide
Type: Thermal
Power Supply: PW4007I (required)
Battery Pak (Ni-Mh): BP4005
Thermal paper: SS112-025A
Purchase: Jaco Electronics (formally Reptron
Purchase Contact:
kbuelow@jacoelect.com
FORM 155.21-O1 (615)
00085VIP
acquired by Jaco)
13710 Reptron Blvd
Tampa, Florida 33626
Phone: 800-800-5441
Fax: 813-891-4056
www.jacoelectronics.com
2
65
Advertisement
Table of Contents
