Playback Procedure - Sony DVCAM DSR-1500 Operating Instructions Manual

Playback Procedure

34
Playback
Note
When controlling this unit from an editing control unit connected to the
REMOTE connector of this unit, set the LOCAL/REMOTE switch of this unit
to REMOTE, turning the REMOTE indicator on. When not, set the switch to
LOCAL, turning the indicator off.
1
Insert a cassette.
For details of cassette insertion see page 25, and for usable cassette types
see page 23.
The cassette is automatically drawn into the unit and the STOP button
lights. A few seconds later, if the STOP menu item under the AUTO EE
SELECT menu item (see page 59) is set to PB, a still image will appear on
the monitor screen.
2
Press the PLAY button.
This starts the playback operation. When the tape is played back all the way
to the end, the unit automatically rewinds it and then stops.
If the following indicators light when a cassette is loaded
Indicator
Cassette memory indicator The loaded cassette contains a cassette memory.
CL indicator
NO EDIT indicator
1
INPUT
dB OVER dB OVER CL REC INHI
U-BIT SERVO
0 0 VIDEO AUDIO
V:SDTI COMPOSITE CH-1 1/2 CH-2 3/4 TC COUNTER NO EDIT REPEAT
-12 -12 SDTI S VIDEO ANALOG ANALOG
i.LINK Y-R,B AES/EBU AES/EBU
-20 -20
SDI SG SDI SG SDI SG
OUTPUT
-30 -30
-40 -40 VIDEO AUDIO
SDI COMPOSITE CH 1/2 HOURS MINUTES SECONDS FRAMES
-60 -60
SDTI S VIDEO CH 3/4 PB F S REC MODE VITC REMOTE
CH- 1 3 CH- 2 4 Y-R,B 48K 44.1K 32K 2CH 4CH EDIT MODE 9P i.LINK
REW PLAY F FWD STOP REC
2
It means:
There is ClipLink log data stored in the cassette
memory on the loaded cassette.
The tape was recorded in the DV format, or a
DVCPRO tape is inserted.
You cannot use it as a recording tape for editing.
LOCAL/
REMOTE switch