Safety Warnings - Kodak X-Omat MULTILOADER 300 Plus Service Manual

SM 3058-6
DURING MAINTENANCE AND REPAIR
·
Wear a grounding strap when you deal with static-sensitive components. Always make
certain that the clip is attached to a properly grounded, unpainted surface.
·
Use a portable grounding mat if you cannot repair components at an ESD-protected
workstation. (Kodak's Customer Equipment Services Division can assist you in setting up
ESD-protected workstations.)
·
Use protective packaging when you transport components from one area to another.
Transparent anti static bags, available from a variety of manufactures, shield your
just-repaired components from further damage.

SAFETY WARNINGS

·
BE CAREFUL WHEN WORKING IN THE CASSETTE OPENER AREA. THE OPENER
MOTOR AND THE OPENER MECHANISM ARE VERY STRONG. THEY CANNOT BE
MOVED MANUALLY. THEY MAY SQUEEZE YOUR HAND AND TRAP YOU IF YOU TRY
TO STOP THEM MANUALLY. NEVER START THE CASSETTE OPENER MOTOR WHEN
SOMEONE'S HANDS ARE IN THE CASSETTE AREA.
·
DISCONNECT THE POWER WHEN TAKING OUT OR INSTALLING THE POWER
SUPPLY. IT IS POSSIBLE TO TOUCH THE MAINS VOLTAGE.
·
IF YOU TAKE OUT SAFETY COVERS OR WIRE TIES TO HAVE EASIER ACCESS TO
PARTS, INSTALL THEM BEFORE YOU MOUNT THE SIDE PANELS WHEN THE
SERVICE CALL OR THE PM IS FINISHED.
·
BE CAREFUL WHEN WORKING ON CIRCUIT BOARDS A4 AND A8. THERE ARE 120
VAC ON THOSE BOARDS. BE ESPECIALLY CAREFUL WHEN MEASURING ON THE
REAR SIDE OF THE CIRCUIT BOARDS OR WHEN A4 IS PIVOTED OUT OR A8 IS
PIVOTED UP. AN ELECTRIC SHOCK MAY RESULT.
·
WHEN WORKING IN THE AREA OF PCB A4, COVER THE VENTING HOLE AT THE
TOP OF THE POWER SUPPLY SO THAT NOTHING MAY FALL INTO IT. TAKE THIS
COVER OFF BEFORE MOUNTING THE SIDE PANELS TO AVOID OVERHEATING OF
THE SYSTEM.
9/98 VI
ESD
KODAK AG, Stuttgart