Adjusting Color Mattes - Sony DFS-700 Operating Instructions Manual

Adjusting Color Mattes

Procedure
You can adjust the color of each color matte individually, and also copy
parameters from other color mattes.
To adjust a color matte, use the following procedure.
1
TITLE DSK EDGE
1 2
EDITOR LUM LUM LUM TRAIL
SHADOW
GPI CRK CRK BORDER BEVELD
EDGE
SET UP MASK MASK MASK SOFT
SHIFT CCR LIGHTING MATTES BORDER
CCR TITLE 1 TITLE 2 DSK
SOURCE SOURCE FILL
AUXILIARY
BLACK 1 2 3 4 5
BACKGROUND
1 2 3 4 5
BLACK
FOREGROUND
BLACK 1 2 3 4 5
1
Press the MATTES button in the menu control section, to display page
1 of the MATTE menu.
MATTE SELECT
INT V
1/2
PAGE F1
2
Press the F1(SELECT) button, to select the color matte to adjust.
INT V (internal video): color matte used for foreground and
background images
BORD (border): color matte used to fill the border applied to an
effect pattern, and as key fill for a title key
EFFECT: general-purpose color matte for use in effects
SHADOW: color matte used for shadows around an input image (fill)
DSKFL (DSK fill): color matte used as key fill for a downstream key
DSKBD (DSK border): color matte used for a downstream key border
FTB: color matte used in place of black in the fade-to-black function
3
Turn the F2(Lum), F3(Sat), and F4(Hue) knobs, to adjust the
luminance, saturation, and hue.
Note
If you vary the luminance of a color matte signal with high saturation,
the saturation is automatically adjusted so as not to go outside the
signal specifications.
2 3
USER PGM
STATUS EDIT
INITIAL EDIT
PATTERN PAGE F1 F2 F3 F4 F5
ADJ
EFFECT
DSK
TRANS RATE PATTERN NUMBER
FTB
SET
SUPER BG FRGD 2 MEMORY FRAME FREEZ MIX EFFECT
6 7 8 MEMORY INT TITLE
VIDEO
INT
6 7 8 CUT
MEMORY
VIDEO
AUTO
INT
6 7 8 MEMORY
VIDEO TRANS
Lum Sat
0-100 0-100
F2 F3
Chapter 3 Basic Operation
SNAP SHOT
LEARN
RECALL
LOCATION
HOLD
INPUT
SET
N/R REV DIRECT DIRECT DSK PVW
RECALL PATTERN
LAST X FADE
TO
7 8 9
INS BLACK
4 5 6
DEL
P IN P
DSK
1 2 3
RST
DOWN UP ENTER
0
PATTERN/KEY PAD
Hue CH2BRD
0-99 BRDMAT
F4 F5
3-57