Demonstration - Sony DFS-700 Operating Instructions Manual

DME Switcher Introduction

Demonstration

To start the demonstration
3-8
Chapter 3 Basic Operation
The DFS-700/700P is equipped with a demonstration function, which
automatically plays back one hundred effects stored in ROM in the
processor unit.
The effects (which by factory default are snapshots 0 to 99) have been
chosen to demonstrate the features of the DFS-700/700P as effectively as
possible.
For maximum effect, the demonstration function uses the signals
connected to VIDEO INPUT connectors 1 and 2, and the internal video
signal.
TITLE DSK EDGE
1 2
EDITOR LUM LUM LUM TRAIL
SHADOW
GPI CRK CRK BORDER BEVELD
EDGE
INITIAL
SET UP MASK MASK MASK SOFT
SHIFT CCR LIGHTING MATTES BORDER PATTERN PAGE F1
ADJ
TRANS RATE
CCR TITLE 1 TITLE 2 DSK SUPER BG FRGD 2 MEMORY
SOURCE SOURCE FILL
AUXILIARY
1 2 3 4 5 6 7 8
BLACK MEMORY
BACKGROUND
1 2 3 4 5 6 7 8
BLACK MEMORY
FOREGROUND
BLACK 1 2 3 4 5 6 7 8 MEMORY
Buttons used for the demonstration
In the pattern/numeric keypad, hold down buttons 1 and 9, and press the
AUTO TRANS button.
The one hundred effects stored in ROM are played back continuously, and
repeated until you press the AUTO TRANS button once more. During the
demonstration, the buttons on the pattern/numeric keypad light in turn in
the clockwise direction.
During the demonstration, the control panel does not accept any operations
other than pressing the AUTO TRANS button.
Demonstration with user-registered snapshots
It is also possible to have a demonstration with user-registered snapshots.
In this case, hold down buttons 3 and 7 in the pattern/numeric keypad, and
press the AUTO TRANS button. During the demonstration, the buttons on
the pattern/numeric keypad light in turn in the counterclockwise direction.
USER PGM SNAP SHOT
STATUS EDIT
EDIT LEARN
RECALL
F2 F3 F4 F5 LOCATION
HOLD
INPUT
EFFECT
DSK
PATTERN NUMBER
FTB
SET
FRAME FREEZ MIX EFFECT
N/R REV DIRECT DIRECT
RECALL PATTERN
LAST X
7 8 9
INT TITLE
VIDEO
4 5 6
INT
CUT
VIDEO
P IN P
1 2 3
DOWN UP ENTER
0
AUTO
INT
VIDEO TRANS
PATTERN/KEY PAD
AUTO TRANS button
SET
DSK PVW
FADE
TO
INS BLACK
Pattern/numeric
DEL
keypad
DSK
RST