Ac Hookups; Before You Use Your Receiver - Sony STR-435 Operating Instructions Manual

AC Hookups

Setting the voltage selector (except for
Canada, Australia, Singapore and Malaysia
models)
Check that the voltage selector on the rear panel of the
player is set to the local power line voltage. If not, set
the selector to the correct position using a screwdriver
before connecting the AC power cord to a wall outlet.
120 V 240 V 220 V
Connecting the AC power cord
Connect the AC power cord from this receiver and
from your audio/video components to a wall outlet.
If you connect other audio components to the
SWITCHED AC OUTLET on the receiver, the receiver
can supply power to the connected components so you
can turn on/off the whole system when you turn on/
off the receiver.
VOLTAGE SELECTOR
(except Canada, Australia,
Singapore and Malaysia
models) (STR-DE535 only)
SWITCHED AC OUTLET
Caution
Make sure that the power consumption of the component
connected to the receiver's AC outlet does not exceed 100
watts. Do not connect high-wattage electrical home
appliances such as electric irons, fans, or TVs to this outlet.
Where do I go next?
Before you use the receiver, go to the next section to make
sure that all the controls are set to the appropriate positions.

Before You Use Your Receiver

Before turning on the receiver
Make sure that you have:
• Turned MASTER VOLUME to the leftmost
position (0).
• Selected the appropriate front speakers (see "Front
Panel Parts Description" on page 12).
• Set BALANCE to the centre position.
Clearing the receiver's memory
Before you use your receiver for the first time or when
you want to clear the receiver's memory, do the
procedure below:
1/u (power)
1
Turn off the receiver.
2
Press 1/u (power) for more than 4 seconds.
"ALL CLEAR" appears in the display and the
items including the following are reset or cleared:
• All preset stations are reset to their factory
• All sound field parameters are reset to their
/
• All index names (of preset stations and program
to a wall outlet
• All adjustments made with the SET UP button
• The sound field memorized for each program
After turning on the receiver
Check the following indicator:
• Press MUTING or MUTING on the remote if the
MUTING indicator turns on.
• Press DIMMER to set the display at any of four levels
of brightness.
Getting Started
DIMMER
settings.
factory settings.
sources) are cleared.
are reset to their factory settings.
source and preset station is cleared.
MUTING
9 US