Ac Hookups; Before You Use Your Receiver - Sony STR-V200 Operating Instructions Manual

Getting Started

AC Hookups

Connect the AC power cord from this receiver and
from your audio/video components to a wall outlet.
If you connect a component to AC OUTLET on the
receiver, the receiver can supply power to the
connected component so you can turn on/off whole
system when you turn on/off the receiver.
ANTENNA
AM CD TAPE/MD TV/DBS
REC AUDIO AUDIO
IN IN
OUT IN OUT
L
FM R
300Ω
y
FM
75Ω
Caution
Make sure that the power consumption of the component
connected to receiver's AC OUTLET does not exceed 120
watts. Do not connect high-wattage electrical home
appliances such as electric irons, fans, or TVs to this outlet.

Before You Use Your Receiver

Before you start using your receiver, make sure that
you have:
• Turned MASTER VOLUME to the leftmost position
(0).
• Set BALANCE to the center position.
Turn on the receiver and check the following indicator.
• Press MUTING on the remote if "MUTING" appears
in the display.
8
AC OUTLET
SPEAKERS AC OUTLET
AC 120V 60Hz
REAR CENTER FRONT
SWITCHED 120V/1A MAX
VIDEO MIX R L R L
AUDIO AUDIO
IN OUT
+ + + +
– – – –
IMPEDANCE USE 8-16Ω
Before using the receiver for the first
time
Do the procedure below to set the receiver's stored
parameters (preset stations, etc.) to their factory
settings.
1/u
SPEAKERS
ØON øOFF
– TUNING + SHIFT
PHONES FM AM MEMORY
b
1
Turn off the receiver.
to a wall
outlet
2
While pressing down VIDEO, TAPE/MD,
and CD, press 1/u to turn on the receiver.
"INITIAL" appears in the display and the
stored parameters are set to their factory
settings.
TAPE/MD
VIDEO TV/DBS TAPE/MD CD TUNER BASS BOOST
DIRECT 1 2 3 4 5 6 7 8 9 0
SURROUND
g
MODE ON/OFF
EFFECT SET UP
DELAY TIME
VIDEO CD
MASTER VOLUME
0 10
BASS TREBLE BALANCE
• • •
–10 10 –10 10 L R