Rear Panel Parts Descriptions - Sony SCD-777ES Operating Instructions (primary manual) Operating Instructions Manual

Rear Panel Parts Descriptions

ANALOG OUT
R
1 ANALOG OUT jacks (5)
Connect to an audio component using the audio
connecting cord.
2 COMMAND MODE selector
Normally set to CD1. When you connect a Sony CD
player other than this player, set to CD2. In this case,
you can control both the other Sony CD player and
this player with CD1/CD2 on the remote. Set to CD1
to control the other Sony CD player, or CD2 to control
this player.
3 Switches depending on amplifier to be connected. For
details, see "About the Switch Marked "STANDARD"
on the rear panel of the player" on page 6.
10
GB
COMMAND
MODE
CD1 STANDARD
CD2 CUSTOM
TA - E1 / N1
L
DIGITAL OUT
CD
COAXIAL
~AC IN
OPTICAL
4 DIGITAL OUT CD OPTICAL connector (5)
Connect to an audio component using an optical
digital cable.
5 DIGITAL OUT CD COAXIAL connector (5)
Connect to an audio component using the coaxial
digital cable.
Note
Only the audio signals of the CD can be output from the
DIGITAL OUT CD connectors shown in 4 and 5. Those of the
Super Audio CD cannot be output through DIGITAL OUT CD.