Setting Time Zone; Upgrading Firmware - Honeywell ControlEdge 900R04-0200 Getting Started

Chapter 5 - Operating

Upgrading firmware

70
see "Set_RTC" in the ControlEdge Builder Function and Function
Block Configuration Reference Guide.
TIP: The recommended poll interval for EFM application is
14.

Setting time zone

1. Click
Configure Date/Time Options
2. Select
Set Time Zone
drop-down list.
Time Zone
3. Select
Automatically Switch to Daylight Saving Time
ATTENTION: Do not power off when upgrading firmware.
If a connected field device or FDAP is OWR300 firmware, the
n
controller must be upgraded to R140 or later releases.
If a connected field device is Honeywell OW R300 or Third party
n
ISA100 2011 device, the controller must be upgraded to R140 or
later releases, and FDAP must be upgraded to OW R300.
For ControlEdge 2020 controller:
n
You can upgrade firmware from R110 to R151, R140 to R151,
l
R150 to R151 directly. For other versions, please contact with
GTAC.
Expansion I/O modules must be upgraded before controllers.
l
For ControlEdge 900 controller, make sure the CPM version is
n
same as or higher than the EPM version. In this case:
No specific upgrade sequence
l
Downgrade EPM before CPM
l
Before upgrading the firmware, it is required to:
Log in as the Administrator to connect the target controller. See
n
"Connecting a controller" on page 1 for more information.
Install the latest ControlEdge Builder on your computer. See the
n
ControlEdge Builder Software Installation User's Guide for details.
under
Miscellaneous
tab, and select the target time zone from the
.
if it is applicable.