Honeywell ControlEdge 900R04-0200 Getting Started page 73

and select the CPM you want to upgrade.
3. Click . The
Upgrade
4. From the
Release Number
target firmware version is displayed.
5. Click , the target firmware name, state, and version are
Next
displayed.
6. Click to transfer and upgrade the firmware.
Next
7. After the boot and application firmware is upgraded, enter the
password to re-connect the controller.
8. Click to revert to the previous firmware version, or click
Go Back
to complete the upgrade.
Proceed
9. The primary CPM is synchronizing with the secondary CPM. Click
OK to complete the firmware upgrade.
The secondary CPM (slot B) becomes the primary one and the
original primary CPM (slot A) becomes the secondary one.
To upgrade the firmware with Off-process procedure
ATTENTION: This procedure could cause loss of control in an
operating process.
ATTENTION: For ControlEdge 2020 controller, if the controller
is connected with I/O modules, you must stop the program
before performing the off-process procedure.
1. From the Start Page, click
CPM (slot A).
2. From the Home Page, select
and select the CPM you want to upgrade.
3. Click . The
Upgrade
The controller is keeping running when you transfer the firmware
to the controller, and will be stopped when you upgrade the
firmware. So when the controller is running, we provide the
interactive mode to control when the controller stops.
If you select the Interactive mode, a dialog appears confirming
l
that the transfer is complete. Click
and the controller is stopped. You can also click
dialog appears.
Upgrade firmware
list, select the target release module. The
to connect the target primary
Connect
Upgrade Firmware
dialog appears.
Upgrade firmware
Next
Chapter 5 - Operating
under
Maintenance
to upgrade the firmware,
to quit
Cancel
,
73