Specifications - Sony MHC-GSX100W, MHC-GSX75 Operating Instructions Manual

To save a tape permanently
To prevent a tape from being accidentally recorded
over, break off the cassette tab from side A or B as
illustrated.
Break off the
cassette tab
If you later want to reuse the tape for recording, cover
the broken tab with adhesive tape.
Before placing a cassette in the tape
deck
Take up any slack in the tape. Otherwise, the tape may
get entangled in the parts of the tape deck and become
damaged.
When using a tape longer than
90 minutes
The tape is very elastic. Do not change the tape
operations such as play, stop, and fast-winding
frequently. The tape may get entangled in the tape
deck.
Cleaning the tape heads
Clean the tape heads after every 10 hours of use.
Be sure to clean the tape heads before you start an
important recording or after playing an old tape.
Use a separately sold dry-type or wet-type cleaning
cassette. For details, refer to the instructions of the
cleaning cassette.
Demagnetising the tape heads
Demagnetise the tape heads and the metal parts that
have contact with the tape after every 20 to 30 hours of
use with a separately sold demagnetising cassette. For
details, refer to the instructions of the demagnetising
cassette.

Specifications

Main Unit
(HCD-GSX100W/GSX75)
Amplifier section
MHC-GSX100W/GSX75
For the U.S. model
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
With 6-ohm loads, both channels driven, from
120 – 10,000 Hz; rated 200 watts (for
GSX100W), 150 watts (for GSX75) per channel
minimum RMS power, with no more than 10%
total harmonic distortion from 250 milliwatts to
rated output.
MHC-GSX100W
Continuous RMS power output (reference):
Total harmonic distortion less than 0.09% (6 ohms at
MHC-GSX75
Continuous RMS power output (reference):
Total harmonic distortion less than 0.09% (6 ohms at
Inputs
VIDEO (MD) IN (phono jacks):
AUDIO IN (phono jacks): 450 mV, impedance 47
Outputs
VIDEO OUT (phono jacks):
PHONES (stereo phone jack):
SPEAKER:
200 + 200 W
(6 ohms at 1 kHz, 10%
THD)
1 kHz, 125 W)
150 + 150 W
(6 ohms at 1 kHz, 10%
THD)
1 kHz, 70 W)
voltage 250/450 mV,
impedance 47 kilohms
kilohms
max. output level 1Vp-p,
unbalanced, Sync
negative, load impedance
75 ohms
accepts headphones of
8 ohms or more
accepts impedance of 6 to
16 ohms
continued
GB
39