Sony MHC-GSX100W, MHC-GSX75 Operating Instructions Manual page 12

Notes on sounds from the
transmitter
When there is no sound, do the following:
– Check the connection of the optional component.
– Check that the optional component is turned on.
– Turn up the volume on the connected optional
component, if the transmitter is connected to the
headphones jack.
– Change the radio frequency using the CHANNEL
selector on the transmitter, then press WIRELESS
again.
– If you connect the transmitter to the analog out
jacks of an audio reproducer, make sure that the
NOISE FILTER switch is set to OFF.
– Make sure that the NOISE FILTER switch is set to
either ON or OFF (If the switch gets stuck between
ON and OFF, the sound will be cut off).
When there is severe hum or noise, do the
following:
– If the transmitter is connected to the headphones
jack, turn down the volume of the connected
optional component. If the connected optional
component has the BASS BOOST or MEGA
BASS function, set these function to OFF.
– If the connected optional component has a LINE
OUT jacks, connect its LINE OUT jacks.
– Change the radio frequency with the CHANNEL
selector on the transmitter then press WIRELESS
again.
– If you connect the transmitter to the analog out
jacks of an audio reproducer, make sure that the
NOISE FILTER switch is set to OFF.
GB
12