Listening To Audio From A Connected Component; Recording Audio Signal From A Connected Component; Recording Audio Signal On A Connected Component - Sony MHC-GN1000D Operating Instructions Manual

Listening to audio from a
connected component
Listening to a connected TV
or satellite tuner
Use the buttons on the unit for the operation.
1
Connect the audio cords.
See "Hooking up optional components" on
page 76.
2
Press TV/SAT.
To switch between the "TV" and
"SAT" function
Hold down TV/SAT and press ?/1 while the
system is turned on. Release ?/1 first, then
release TV/SAT. The system switches the
function from "TV" to "SAT" or vice versa.
Note
If the sound is distorted or too loud when "TV" is
selected, change the function to "SAT".
Listening to a connected VCR
1
Connect the audio and video cords.
See "Hooking up optional components" on
page 76.
2
Press VIDEO on the unit.
Start playing the connected VCR.
Note
The video signal from the connected VCR is only
output through the VIDEO OUT jack of this unit.
Tip
You can press FUNCTION +/– repeatedly to select
"TV", "SAT" or "VIDEO".
GB
78
Recording audio signal
from a connected
component
1
Connect the audio cords.
See "Hooking up optional components" on
page 76.
2
Start recording manually.
See "Recording onto a tape manually" on
page 55.
Recording audio signal on
a connected component
Recording the audio signal on
a connected component
1
Connect the audio cords.
See "Hooking up optional components" on
page 76.
2
Start recording.
Refer to the operating instructions provided
with connected component.
Recording the audio and video
signals from a VIDEO CD onto
a video tape
1
Connect optional audio cords from the
AUDIO OUT jacks and the supplied
video cord from the VIDEO OUT jack to
the audio and video input jacks of your
VCR.
2
Start recording.
Refer to the operating instructions provided
with connected component.
Note
The audio signal from the AUDIO OUT jacks may cut
off for a moment during some operations such as when
you press SOUND FIELD, AUDIO or KARAOKE
MODE.