Sony MHC-GN1000D Operating Instructions Manual page 11

7 For models equipped with a voltage
selector, set VOLTAGE SELECTOR to
the position of your local power line
voltage.
Depending on the model, the VOLTAGE
SELECTOR may differ.
Brazilian model
only
VOLTAGE SELECTOR
220V
127V
220V
* Saudi Arabian model : 120 - 127V
8 Connect the power cord to a wall
outlet.
The demonstration appears in the display.
When you press ?/1
and the demonstration automatically ends.
If the supplied adaptor on the plug does not
fit your wall outlet, detach it from the plug
(only for models equipped with an adaptor).
For Saudi Arabian model, see "Note on
power cord plug shapes" on page 2.
9 (Except for Latin American and
Russian models)
Set the color system to PAL or NTSC
depending on the color system of your
TV.
The default setting for color system is
different depending on the area.
Each time you perform the procedure
below, the color system changes as follows:
y
NTSC PAL
Use the buttons on the unit for the
operation.
1
Press ?/1 to turn off the system.
2
Press ?/1 while holding down X.
The system turns on automatically and
the color system is changed.
"COLOR NTSC" or "COLOR PAL"
appears in the display.
Other models
VOLTAGE SELECTOR
220V 120V*
230-240V
, the system turns on
Notes
• Keep the speaker cords away from the antennas to
prevent noise.
• Be sure to match the color of the speaker terminals on
the unit and the connectors.
• Be sure to connect the speakers securely and
correctly. When connecting speaker cords, insert the
connector straight into the terminals.
• You cannot set the color system in the Power Saving
Mode (see "Turning off the display" on page 71).
• When you play back a VIDEO CD recorded in a
different color system from the one you set to the
system, the picture image may be distorted.
To connect optional components
See "Hooking up optional components" on
page 76.
Inserting two R6 (size AA)
batteries into the remote
Operating a Sony TV
You can use the following buttons to operate a
Sony TV. These buttons have been marked in
orange. To use these buttons, hold down TV
before pressing the button you want.
To
Turn the TV on or off
Switch the TV's input
source between the TV
and other input sources
Select the TV channels
Adjust the volume of the
TV speaker(s)
* For double digit number, hold down TV and press
-/--, then press the number. (For example, hold down
TV, press -/--, then 2 and 5 for entering 25.)
Hold down TV and
press
?/1
TV
TV/VIDEO
TV CH +/– or numeric
buttons*
TV VOL +/–
continued
11 GB