Specifications - Sony LBT-XGR60 Operating Instructions Manual

Precautions (continued)
Cleaning the tape heads
Clean the tape heads after every 10 hours of use.
Make sure to clean the tape heads before you start an
important recording or after playing an old tape. Use
separately sold dry-type or wet-type cleaning cassette.
For details, refer to the instructions of the cleaning
cassette.
Demagnetizing the tape heads
Demagnetize the tape heads and the metal parts that
have contact with the tape every 20 to 30 hours of use
with a separately sold demagnetizing cassette. For
details, refer to the instructions of the demagnetizing
cassette.
GB
32

Specifications

AUDIO POWER SPECIFICATIONS
(LBT-XGR6 USA models only)
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 6 ohm loads, both channels driven, from
120-10,000 Hz; rated 140 watts per channel
minimum RMS power, with no more than 10%
total harmonic distortion from 250 milli watts
to rated output.
Amplifier section
North American models:
LBT-XGR6
Continuous RMS power output (reference)
Total harmonic distortion less than 0.07%
Other models:
LBT-XGR80
The following measured at AC 120/220/240V, 50 Hz
DIN power output (rated) 125W 2 + 125W 2
Continuous RMS power output (reference)
LBT-XGR60
The following measured at AC 120/220/240V, 50 Hz
DIN power output (rated) 150 + 150 watts
Continuous RMS power output (reference)
160 + 160 watts (6 ohms at
1 kHz, 10% THD)
(6 ohms at 1 kHz, 70 W)
watts
(6 ohms at 1 kHz, DIN)
170 W 2 + 170 W 2
(6 ohms at 1 kHz, 10% THD)
(6 ohms at 1 kHz, DIN)
200 + 200 watts
(6 ohms at 1 kHz, 10% THD)