Timer-Recording Radio Programs - Sony LBT-XGR60 Operating Instructions Manual

Recording a CD by specifying
track order
— Program Edit
1
Load CDs and a recordable tape.
2
Program CD and tracks following step 1
to 6 in "Programming the CD tracks" on
page 10.
3
Press CD SYNC.
Deck B stands by for recording.
4
Press DIRECTION repeatedly to select
g to record on one side.
Select j (or RELAY) to record on
both sides.
5
Press X.
Recording starts.
Tip
To check the required tape length for recording a CD,
press EDIT after you have loaded a CD and switched
function to CD. The required tape length for the
currently selected CD appears, followed by the total
playing time for side A and side B respectively (Tape
Select Edit).
Notes
• You cannot use Tape Select Edit for discs
containing over 20 tracks.
• You cannot use this function when Program Play
mode has been set. After clearing the entire
program, follow the above procedure.
Timer-recording radio
programs
To timer-record, you must preset the radio
station (see "Presetting radio stations" on page
11) and set the clock (see "Setting the clock"
on page 8) beforehand.
1
Tune in the preset radio station (see
"Listening to the radio" on page 12).
2
Press c/CLOCK SET (or CLOCK/TIMER
SET on the remote).
3
Press R/r repeatedly to select "REC
SET," then press ENTER.
"ON" appears and the hour indication
flashes in the display.
4
Set the time to start recording.
Press R/r to set the hour, then press ENTER.
The minute indication starts flashing.
Press R/r to set the minute, then press
ENTER.
5
Set the time to stop recording following
the above procedure.
The start time appears, followed by the stop
time, the preset radio station to be recorded
(e.g., "TUNER FM 5"), then the original
display appears.
6
Insert a recordable tape into deck B.
continued
GB
15