Quick Start; Configuring The Manager - Symbol PDT 8100 Series Supported Equipment Manual

Toolbar
Found under the menu bar, the toolbar provides shortcuts to major features. The toolbar
can be turned on or off by changing the Toolbar parameter found on the
shortcuts available from the toolbar are as follows:
The PowerNet Twin Client Manager is now successfully installed and ready for use. The
section below entitled Quick Start provides detailed instructions for quickly configuring
the terminal and starting a Telnet session.

Quick Start

This section describes how to prepare the Twin Client Manager and the Symbol terminal
for a Telnet session with the host. Following an initial serial download, the terminal
software and configuration are managed automatically, over the wireless network.
Symbol terminals are normally delivered with Symbol files pre-installed. However,
Note:

Configuring the Manager

The first step is to configure the Twin Client Manager to meet site-specific requirements,
and then prepare it for the automatic management of the terminal software and IP
addresses. This simple procedure will require only a few minutes to complete.
Setting the Emulation
Click on
menu, as shown below.
Supported Equipment Manual
Create a new terminal configuration.
Open an existing terminal configuration.
Save the current terminal configuration.
Download the configuration to the terminal.
Download software to the terminal.
Configure terminals automatically over the wireless network.
View the PowerNet Twin Client Manager version.
if the terminal does not have those files installed refer to the section entitled
Downloading Symbol 8140 Terminal Files before proceeding.
, ,
Start Programs PowerNet
•
March, 2006
, and
Twin Client Manager
Software Management
menu. The
View
. Select the
Settings
2-5