Sony DHC-NX5MD Operating Instructions Manual page 75

Disc Full!
There is no time remaining on the MD.
Eject
The MD deck is ejecting the MD.
Impossible
• You tried to make an impossible editing
operation.
• You cannot combine the tracks due to the
system limitations of MDs.
Incomplete!
The S.F Edit (changing the recording level after
recording, Fade-in, Fade-out) operation was not
performed properly because the system was
moved while recording was in progress or the
MD is damaged or dirty .
Initialize
The power was off for a long time, so the
system is initializing itself.
Name Full!
There is no more space to store track or disc
titles.
MD No Disc
There is no disc in the MD deck.
MD No Name
You tried to show the title of a non-labelled
disc or track. Track number is displayed
followed by "MD" in case of a track.
No Change
While attempting to change the recording level
after recording, you pressed ENTER/YES
without actually changing the recording level,
so no change was made.
Over
You have reached the end of the MD while
pressing and holding M during playing pause.
Overwrite
You specified recording over recorded tracks
on an MD during recording.
Push MD STOP
You pressed PLAY MODE during play.
—Rehearsal—
The MD is playing the specified dividing point
for confirmation during the Divide function.
S.F Edit!
You attempted to perform another operation
while in S.F Edit (changing the recording level
after recording, Fade-in, Fade-out) mode.
S.F Edit NOW
You pressed ?/1 while in S.F Edit (changing
the recording level after recording, Fade-in,
Fade-out) mode.
Smart Space
The signal was input again after silence
continued for about 3 or more but less than
about 30 seconds during digital recording.
SYNC NOW
You pressed a button not needed for recording
during Synchro-recording.
Text Protect
There is CD TEXT information which cannot
be recorded on the MD.
TOC Reading
The MD deck is reading the TOC information
of the MD.
TOC Writing
The MD deck is writing the information of
recorded or edited contents.
Track End
You have reached the end of the track while
adjusting the dividing point during the Divide
Function.
USE MD AREA!
You tried to perform an operation with the jog
dial, m or M on the A/V control amplifier
with the function set to MD.
Use MD JOG, MD m or M.
continued
75