Sony DHC-MD333 Primary Operating Instructions Manual page 46

Labelling the preset station
(continued)
4
Press ENTER/YES.
The cursor starts flashing.
Cursor
5
Press CHARACTER repeatedly
until the type of character you want
appears.
Each time you press the button, the
display changes as follow:
A (Upper case) n a (Lower case) n 0
(Numbers) n ! (Symbols)*
n (Space)** n A...
* You can use the following symbols.
!"#$%&'() +,–./:;<=>?@_`
** To enter a space
Go to the step 6. You cannot label a
blank space for the first letter.
6
Press +/– repeatedly until the
desired character appears.
7
Press CURSOR /.
The character you selected in step 6 stops
flashing and the cursor shifts to the right.
J
Cursor
8
Repeat steps 5 through 7 to
complete the entire title.
If you enter an incorrect character, press
CURSOR ? or / until the character
you want to change flashes, then repeat
steps 5 through 7. To erase a character,
press CANCEL/NO while the character
is flashing.
46
LEVEL SYNC -
DBFB
PRESET
1
LEVEL SYNC -
DBFB
PRESET
1
9
Press ENTER/YES to complete the
labelling procedure.
To cancel labelling
Press EDIT.
To check the titles
Press DISPLAY.
Each time you press the button, the display
changes as follows:
The station name ˜ Frequency
To erase the name
Start over from steps 1 through 5 and press
CANCEL/NO repeatedly until the label
disappears.