Table of Contents
Advertisement
1.
WARNING! Always make sure the Power Switch (1) is in its "OFF"
position and the Plasma Cutter is disconnected from its electrical outlet
and air supply source before performing any inspection, maintenance, or
cleaning.
2.
Before each use, inspect the general condition of the Plasma Cutter. Check for
misalignment or binding of moving parts, cracked or broken parts, damaged
wiring, and any other condition that may affect its safe operation. If abnormal
noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
3.
Before each use, clean or, if necessary, replace the Nozzle (6A) and Electrode
(3A). (See Assy. Diagram.)
4.
To change the Fuse (9), unscrew and remove the Fuse Cap. Remove the old
Fuse, and replace with a new Fuse. Then, replace the Fuse Cap. (See Figure A.)
5.
To clean, use a shop vacuum cleaner, or use compressed air.
6.
When storing, make sure to store the Plasma Cutter in a safe, clean, and dry
location.
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST
AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY.
NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION
OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO
MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO
REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTUER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS
REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED
TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND
LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR
REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION
OF REPLACEMENT PARTS THERETO.
SKU 90648
90648.p65
15
INSPECTION, MAINTENANCE, AND CLEANING
PLEASE READ THE FOLLOWING CAREFULLY
PAGE 15
12/1/2003, 10:56 AM
Advertisement
Table of Contents
