Table of Contents
Advertisement
8.
Never leave the Plasma Cutter unattended when it is plugged into an
electrical outlet. Make sure to unplug it from its electrical outlet before leaving
the area.
9.
Do not allow children to handle or play with this product.
10.
Store idle equipment. When not in use, tools and equipment should be stored
in a dry location to inhibit rust. Always lock up tools and equipment, and keep out
of reach of children.
11.
Do not use this product if under the influence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgement or reflexes are
impaired while taking drugs. If there is any doubt, do not attempt to use this
product.
12.
Industrial applications must follow OSHA requirements.
13.
Maintain this product with care. Keep this product clean and dry for better and
safer performance.
14.
Maintenance: For your safety, service and maintenance should be performed
regularly by a qualified technician.
15.
Check for damaged parts. Before using this product, carefully check that it will
operate properly and perform its intended function. Check for damaged parts
and any other conditions that may affect the operation of this product. Replace
or repair damaged or worn parts immediately.
16.
Connect the earth ground as near as possible to the operating area. Earth
connections to structural parts of the building or other places distant to the oper-
ating area will reduce their effectiveness and increase the danger of electric
shock.
17.
Do not pass equipment cables through or near lifting chains, crane cables,
or any electrical lines.
18.
Do not touch the electrode if you are in contact with the workpiece, ground,
or another electrode from a different machine.
SKU 90648
90648.p65
8
PAGE 8
12/1/2003, 10:56 AM
Advertisement
Table of Contents
