FOR SPOT WELDING LOW-CARBON STEEL
INSPECTION, MAINTENANCE, AND CLEANING
Caution: Always disconnect the Spot Welder from its electrical power supply source
1.
before performing any inspection, maintenance, or cleaning.
2.
Before each use, inspect the general condition of the Spot Welder. Inspect switch,
power plug and cord assembly, and extension cord (if used) for damage. Check for
loose screws, misalignment, binding of moving parts, broken parts and any other
condition that may affect its safe operation. If abnormal noise or vibration occurs,
disconnect the Spot Welder from its electrical supply source immediately and have
the problem corrected before further use. Do not use damaged equipment.
SKU 45690
RECOMMENDED PRACTICES
TROUBLE SHOOTING GUIDE
PAGE 10