Inserting Two Size Aa (R6) Batteries Into The Remote; Setting The Clock - Sony CMT-EP707 Operating Instructions (CMTEP707) Operating Instructions Manual

3 Connect the FM antenna (except for
European model).
Extend the FM lead
antenna horizontally.
4 Connect the power cord to a wall outlet.
If the supplied adaptor on the plug does not
fit your wall outlet, detach it from the plug
(only for models equipped with the
adaptor).
To turn on the system, press [/ 1 (power).
Note
When carrying this system, make sure that all discs
are removed from the system.
When carrying this system
Perform the following procedure to protect
the CD mechanism.
1 Make sure that the disc is removed from
the system.
2 Re-tie the strip that was attached to the
CD tray when you purchased the system.
3 Press [/ 1 to turn off the system.
4 Unplug the power cord.
Inserting two size AA (R6)
batteries into the remote
Tip
When the remote no longer operates the system,
replace both batteries with new ones.
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage.

Setting the clock

1
Turn on the system.
2
Press CLOCK/TIMER SET on the
remote.
3
Press CLOCK/TIMER SET on the
remote to select "SET CLK", then press
ENTER.
4
Press . or > on the remote
repeatedly to set the hour.
5
Press ENTER.
6
Press . or > on the remote
repeatedly to set the minute.
7
Press ENTER.
The clock starts working.
If you make a mistake
Perform from step 1.
Note
The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.
e
E
E
e
7
GB